裝載機的操作要等油溫穩定后
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：654次
裝載機的所有操作都需要等到油溫下降后再進行操作，下面主要給大家介紹一下裝載機操作要點，希望對大家有所幫助。
1、裝載機接油容器放在放油螺栓下，取下螺栓，并放油。為了達到避免山東裝載機設備油箱內的油突然溢出，松開螺塞，并逐漸取下螺栓。
Shandong loaders drip container placed under the oil drain plug, remove the bolts, and drain. In order to achieve avoid oil Shandong loader equipment suddenly overflow tank, loosen the drain plug, and gradually remove the bolts.
2、待得裝載機油箱放油后，裝在螺塞并擰緊，接油容器放在小裝載機變速箱濾油器下。
After Shandong loaders to be too put oil tank, mounted on plug and tighten, then the oil container on a small loader gearbox oil filter.
3、取下裝載機變速箱濾油器放油螺塞，放油后擰緊螺塞，取下螺塞、蓋，并取出濾網。
Remove Shandong loader gearbox oil filter drain plug, after the release of the oil drain plug and tighten, remove plugs, cover, and remove the filter.
4、清除粘在山東裝載機濾網上的贓物，然后用柴油或清洗油清洗，重新安裝濾網。
Clear stuck on the filter swag Shandong loader, then wash with diesel or oil cleaning, re-install the filter.
5、裝載機經加油口注入一定數量的機油，加油時，檢查油位。
Shandong loader through the oil filler injected a certain amount of oil, refueling, check the oil level.
